My "Yamamutt" Project
by PerformanceX
objective: take an ordinary old P.O.S. Yamaha Phazer and improve it (so it becomes slightly less of a P.O.S.)
***I am now parting out this sled. Email performancex@usa.com for anything you need.
page 1 of 6 page 2 of 6 page 3 of 6 page 4 of 6 page 5 of 6 page 6 of 6
SNOW FLAP---
After I got the skid in, we got a little snow. I took the sled out for
some rips around the yard and up and down the road. I found out that the
snow flap was now way too short with the new ride height. Short flap=snowy
back!
My car just happened to crap out for good about the same time, so I pulled two of the mud flaps off and used them for a snow flap extension:
I held them together in the center with some 1/16" aluminum:
Now it's long enough so it just touches the ground when I sit on the sled
(up to spec for my racing future):
SNOW VENT---
Darn near forgot! I had painted the snow vent door in the nose cone
red, too:
MORE FOOT GRIP---
The rear bracket bolts poking thru the running board provide such good grip, I decided these holes up toward the front could use some of the same grip:
So there we go. I put some 1/2" long 1/4" bolts thru the holes.
contact: performancex@usa.com